good guide used this when i got mine
Any Dual Mod will require for Ground and Power to be connected.
Even if for separate Console Cables.
Just a few days too late!
Thank you very much. This saves me the trouble of going crazy trying to find all the correct parts.
Hey guys, i’m interested in modding one of these, but where would you buy one? Play Asia is out of stock, i’m not sure of another site that will carry it?
Hi guys, I was waiting for the custom harnesses to order stuff on etokki and finally there’re here but that joystick harness is useless for the Sanwa JLF-TP-8Y-SK used in the tutorial (and avaiable on etokki) right? If so, laugh will you sell the right joystick harness too?
Wire Harness from laugh made for JLF-TM-8 or other Joystick without PCB. :wgrin:
Wire Harness from laugh not for JLF-TP-8 or other Joystick with PCB. :sad:
Solution: Don’t use JLF, it sucks.
Buy Seimitsu.
i had same problem with 5 buttons being stuck “on” idk what i did either if you found a fix gratz! currently going to save a few pennies and order a new pcb soon.
i just think we got UNLUCKY ahha
The Paewang PCB makes modding the Saulabi 4K very easy 
Just a standard wiring job, nothing fancy (I wasn’t paid for doing this for a friend haha). The electrical tape on the joystick is because the QDs I had were just a tad too big to fit snugly onto the Fanta’s microswitches. I tried crimping them a bit tighter, but they just kept bending (ugh). So, I figured since no one was going to be seeing inside, it didn’t matter – they’re definitely not moving! Thanks laugh!
Can someone please try the Datel Paewang pcb on the new xbox 360 S system to see if it works.
also check does this work on the PSN 3.5 firmware update.
also check does this work on the PSN 3.5 firmware update.
My Paewang works after 3.5…
Working here on the Bewlix I just received from you
It’s probably been stated before, I don’t know. But if I were to solder Sanwa 24mm start buttons to the Yayflash pcb, how would I go about doing this? I heard a long time ago you can just scratch something on the pcb to expose points to solder to, but can someone be more specific?
Scratch the black of where you want to solder to.
But everything on the Mayflash should already be exposed.
http://img402.imageshack.us/img402/9444/sv102549.jpg
http://img188.imageshack.us/img188/1406/sv102551.jpg
Hi, I bought a Sanwa JLF-TP-8Y-SK on etokki and now I realized that i don’t have the cable from the 1st img, which connects to the JLF
there is another way to install?
thx 
You can solder to the pins that the connector would normally go onto.
Or you can just solder directly to the Microswitches.