The pcb pin layout pics are all dead links…
Here:
this is the 360 version no?
Yes, it is the 360 version. I have a picture of the Xbone version somewhere, I’ll post it later.
Here is the Xbox One version:
Thanks guys!!!
So I am assuming the pin next to it is the ground for the 360 version?
yes
if u want a stick that breaks without having to throw it on the floor then get a razer atrox.
I
On the other hand if you want it to break after using it for about 2 years just by opening it/closing it, then by all means by a razer atrox
@d3v can attest to that
@Vicko
I want to use the same astrox original connector, so I cut the trace below image that you posted previously (it seems it he GRD that we cut??) But when I switch, it does not recognise my FC4 pcb?
I’ve also wired the VCC and GRD to the connector, detects the astrox PCB okay. Any ideas?
https://dl.dropboxusercontent.com/u/1570228/dpdt%20atrox.jpg
///==============
Do I need to cut these as well? a bit confused now…
Razer Atrox is a piece of Crap, it will break on you. Right away the unlock button broke on me.
and I seen the Atrox ether has the gas strut break off with no way to reattach it or the hinges them selves.
You can add my name to that list.
Sorry no, not gnd, cut only the USB, which is the 2 points in the circle on your 2nd picture.
@Vicko Okay, I’ll just have to fix up my mistake…
So the second picture is showing that we cut the d- and d+?
Yes
@Vicko
Thanks for the helps, I fixed the GRD I cut with a bridge -.-
then just cut the circle part for the signals and all working 
Cheers all !!!
So later today I’m going to be picking up a PS360 from somebody in my area. The plan is to switch the stock Atrox Xbone PCB with the PS360 completely, and then whenever I get my hands on an Imp, dual mod the Atrox Xbone PCB so it’s the secondary PCB and so I have Xbone support. How do I install the PS360 so that the Razer button LED and Lock switch still work and I can still use the Razer cable?
I would just wait. You’ll have to cut all the harnesses and wires to get it to work with the ps360+ unless you’re just going to solder from the existing PCB, but you said switch so it sounds like you’re pulling out the original PCB.
To answer your question about the LED and lock switch, you’ll probably need a resistor for the power line and just wire that to 5v and the GND to GND. Wire your lock switch wire (whichever it is) to GND as well.
If I keep the Atrox as the primary PCB, do I need to cut any traces?
Did anyone test with brook converters?
My atrox360 is dual modded with cerberus and I want to use it on ps4
Not sure if this is answered but MS confirm XB1 stick will work on Win10.
At least for KI on Win10.
I can’t find the source right now but I remember they confirm it.
I use brook “360/one to ps4” with my Razer XB1 on ps4. it works.