I see. It’s FA that has the custom harness service though, right?
I must have missed that thread.
I believe Bryan said that they are focusing on the releasing the Kaimana first, then will try to follow with the new harness after.
We are releasing the Kaimana first, the same company is doing the wiring harnesses for the Kaimana as we were going to have do the premade harnesses.
When we did the Voltech’s we were the only ones doing prebuilt harnesses, those were released last November, and we were trying to do 100% Molex made in the USA harnesses. With the release of other distributors harnesses using the less expensive overseas wiring as a base we were debating doing an overseas version also. Our quotes were allow for only black techflex at this time but the cost would be around $15. Ideally the harness would be launched with female .100 headers to plug directly into the Kaimana Shield or Dual… oops, I’ll stop there 
Masterful hint drop^
Hey Bryan, I had some difficulty paying with Paypal too. I couldn’t see the link under the credit card info using Chrome, but had no trouble seeing it and paying with Firefox.
I too was using Chrome when I experienced the same issue.
Don’t worry about the diagram for the pele led, I didn’t use it after all. I might bug you about it later, if I find a use for it.
Hint? what hint?
Check out the paypal link and let me know if it’s better
There is no button but it says “Pay with PayPal”. Looks like it still isn’t working on Chrome.
hmmmm, comes up in my chrome window on the payment options page…
No use for the Pele! they are good for a bunch of stuff
Hey armi what SMD LEDs do you use in your RGB led boards?
New or old led boards… btw, I FINALLY have tracking for the wires!!!
The ones you use on the Uilas
RGB 5050 for the color
If I get a set of Uila S Flash LEDs can I just use the white leds with an FGWidget?
Yes, and you can use any of the colors individually or together, or you can just use the white LEDs on the board. All of these will work with the FGWidget.
I am going to start working on answering questions here or by email on a support page. We are setting this up as a Wiki and hope people will contribute their own experiences and knowledge… here’s one example for silent pads in hitbox… the homepage is support.paradisearcadeshop.net . Any thoughts?
Also, is there a pre-installed resistor that I would need to remove from the Uila S Flash?
@armi0024 Is $20 a standard for shipping to Canada? I want to get some “Paradise OBSFS Silent 24/30mm Pushbutton pads” but $20 seems a bit much for some thin pads.