I decided to go with the pink button instead but thank you for checking it out.
LS-32 series round main guide revives
Question: I ordered the .187 wire on accident. Susan said they would swap them for .110 wires, but that didnāt happen. Is there any reason I canāt just use the .187 connectors on my Sanwa buttons?
Iām not upset about this or anything, I just wanna build my stick this weekend, since my tek case will arrive tomorrow.
I have never tried to use a .187 on a .110 but the .187 QD should be too big to use for sanwa buttons, they would be too loose to make a soild connection with the wire.
Well, it is obviously not made for the Sanwa connector, but my question is will I actually experience issues down the road? Having plugged one into a Sanwa button, and say for certain that the connection is strong enough to convey a stable electrical signal, but for how long?
I have never used them on buttons before but it should do until you can get some .110. The only problem you may run into is the wire coming off the connector from fast movements or just falling off on its own.
Ok thanks, Iām happy to hear that. Iāll probably order some replacement wire later on, but right now Iām just tired of using my keyboard for fighters.
if you want it to stay as a secure connection, just use the crimpers or pliers to squeeze it on the contact a little more and you should be fine.
I only had .187 lying around for one of my sticks and they are still on there just fine
Iāve used .187 on the QD terminals on sanwa and seimitsu switches. They work perfectly fine, as long as the lead makes contact with the terminal you should be good. Hell you could use .250 on them if you wanted to with no issue. The connection will be fine and you shouldnāt have to worry about any inconsistencies or loose connections.
I knew I should of ordered more little kahuna pads, theyāre so small I lost one and I have no idea where it went. Only my select button doesnāt have one. I am going to order extra next order I place.
I donāt suppose you would have a diagram or schematic for the pele led ring, would you? I didnāt order a harness or anything, and I just want to figure out which pins are which colors, without having to use trial and error.
Send me your address via PM. I have some spares. Iām really excited to see what you think!
Edit: Allow me to clarify. I could send one at the end of next week or so, at the moment I do not have a car with no way to get even small envelopes out at the moment.
You donāt need to send me any Moonchilde itās just my select button that doesnāt have one. Unfortunately I havenāt had much time to use my new stick. Hopefully next week I can get some time in and put the kahuna pads to the test.
Still no PayPal support??? :ā(
@Evolution169 We do, Iāll post it later tonight
@YellowCan We can send one first class mail if you need it
@iNendoi Should be, Iāll check on this again. Our credit card processing is all through paypal. Iāll make sure regular paypal is on also. It automatically put quick check out buttons on every product, I didnāt like that so I made some modsā¦ Thank you for letting me know!
really nice work!
@armi0024
Itās ok I donāt need one. Itās my own fault for not putting them in a cup or bowl while taking the buttons out.
I remember a thread about having prebuilt wire harness? Whatās the status on those?
FocusAttack has those.
PAS has them as well