Order spot is up again! Finishing up assembly on quite a few tonight and will knock the rest out as the week progresses :tup:
Orders seem like they’re up! Just ordered one 
Just ordered one as well 
ordered the s
congrats clayton!
Did you get any of the blue phreak mods decals. I want one to match my Chun-li stick.
So… any idea when these will ship out? 
Nah, I only got stickers in Green since that was all the was available at the moment. Next time I order stickers I’ll get more and a variety of colors for people.
I’m finishing programming/testing/packing the stack of them tonight, they will be in the mail later tonight or tomorrow at the latest.
Sounds good. I guess I’ll receive it mid-next week then
Ordered one for my x360 Round 2 TE PCB thats it’s going in my VAS-TE =D
For the USB cable, do you just cut it right from the board and put each of the 4 wires in their respective spots in the punch terminals on the TEasy Strike? It was a little hard for me to 100% understand, seeing as this will be my 1st mod and the TEasy install vid didn’t actually show it being installed, although I did watch all the TEasy in under 30 vids.
I covered what the new changes in a new vid… in a nutshell, cut above the glue on the 360 board, pull the heat shrink wrap off of the individual usb lines, and off of the main usb cable (its covering part of the usb lines)… this maximizes the length of usb cables (so you dont have to strip any wires)… then open the punch terminals, insert wire all the way to the back, press down the tab all the way
[media=youtube]gXUw8U0GNrg[/media]
Thanks Sounds easy enough.
Soooo, I’m sold out of the round 1/2 versions.
That was fast. Excuse me while I pick my jaw up from the floor. Emailing my component contacts now to see if they can rush order my parts to reduce out of stock time.
Damn, I really wanted one! Is it autodetect or do I have to hold a specific button when connecting it to a PS3?
Auto-detect.
TEasy question
Hi sorry for being lazy (hoping I’m not the only beginner with this stuff and someone’s prolly already asked, but there’s like 29 pages and too much jargon to wade through) but could someone explain what this thing does? I’m not savvy with electronics or soldering (I’m also thick lol) so lamen’s terms would be greatly appreciated.
Thanks
^It lets you use your fight stick on both the 360 and PS3 pretty much.
Damn that was fast O_O Good thing I didn’t wait on this one lol.
When will you have more in stock? Can I preorder?