na i was testing it on 3rd stike the anniversary disc my xbox is also soft modded do i have to do anything first i never tried anything but loading directly into the game then plugging it in
I selected SFAC from the EvoX menu, selected Third Strike, and everything worked fine. I even replugged it at the ‘will you load your xbox data?’ screen, and it still worked fine. Played a few rounds in arcade and had no problems.
im using the actual disc though does that matter?
Shouldn’t. If it did matter, it would work with other games and not that one, but I’d bet money you’d have the same problem on other games.
hum idk what it would be then it works fine on ps2 and dreamcast ps3 and xbox 360 but not on xbox 1 the top left light just stays on and thats it and its my second cable i brought it does not go into the button mapping on the pc either it ends up always that all 4 light stay lit after i hold it for a while (turbo,direction,guide) but plugs into the pc fine if i hold the guide it connects as a 360 vlx and if i just plug it in connects as a wired controller so all fine my only problems are xbox 1 and button mapping mode
Update the firmware. Either the firmware’s old or you aren’t entering the mapping mode correctly, and updating would fix one of those possibilities. After that, try again; if it doesn’t work on Xbox1, it’ll be the cable.
i updated the firmare from 10 to 11 is there a newer version?
Nope. Plug it into a PC, move Guide and Turbo and hold the stick in a direction; after a while, like 20 seconds or so, the LEDs around the Guide button will turn off. That’ll tell you you’re in button mapping mode.
alright ill try this first i tried so many times though ill hold all turbo guide and up for about 30 seconds and see what happens
u think i got two bad xbox cords?
after i read this post toodles i got it to work the way i read it i thought i had to hold all at once when i plugged it to the pc but thats not the case
so u think i just got 2 bad xbox cords imma ask now if he tried it before he sent it as well
1 last question how would i button map other consoles like dreamcast n ps2 etc
Same way. The remapping steps are the same, it just saves them for whatever console you’re plugging into when you do it. If you’re plugged into a PC/PS3 when you do it, it uses those new mapping whenever you’re plugged into a PC/PS3. If you do it on a Dreamcast, it’ll use that new mapping whenever you’re plugged into a Dreamcast. Each system’s mappings are separate from each other, so changing the Dreamcast mapping won’t affect the Saturn mapping, for instance.
Is there any step by steps on how to use the KNserts and the Widget with the TE Kitty board confused as to where to hook up the wires for VCC and GRND on the TE Kitty
Use the bottom most (Xbox section, V Red hole) screw terminal for the VCC, and any of the Shld or G Blk screw terminals for ground (top most screw terminal being the easiest to locate and use). As for the *_IN points for connecting the button signals, best to get those by soldering wires to the underside of the button distrobution block.
Anybody post only pics so I can see where I should be soldering things to?
ok so like i did the mapping on the pc for ps3 do the same plugged into a dreamcast or any other console for that matter and it will button map the same way correct?
and back to the xbox cord u think i just ended buying two bad cords?
hey toodles he said he tried the xbox cable on a mc board and it worked perfect any thoughts?
Nope.
dam that sucks alright
hey toodles i need 2 TE Kitty do you have it in stock thanks