@UltimateChocolate you would be better off just buying the 309. One of the best Crowns and should come with the same switches found on Korean levers such as the Green Lever, Fujin V2 and airbag. you can always change the switches with this stick and micro switches should have some effect on diagonals, i think something was discussed earlier about the switches inside the Golden Fanta that confirms this.
@VarmintBaby I personaly dont know of any mods other than a different grommet and different switches. You might also benefit from a 309 stick too.
I have a 307 and a 309mj, and the 307 is trash, comparatively. The geometry of the 307 results in huge activation areas for the cardinal directions and tiny diagonals that are hard to hit. Also, the throw of the 307 is huge, to no benefit. I donāt think thereās anything that can fix the 307.
The 309 is simply a better design. I plan on picking up a Helpme version when I get a chance.
Anywho thatās a link to one of my old Taeyoungās (right) pictured with a Myoungshin Fanta. I might see about 3d printing just the plastic body. Any advice is welcomed.
And does any know if a Myoungshin will fit inside a HORI EX2? I just got curious after seeing @hibachifinal post his two red sticks on twitter a while back one with Sanwa and one with Myoungshin. It looks like it has a Noir layout and would be great for Tag 3 IMO. I know itās hard to mod but it would be great just to know if itās possible.
i seen a lot of 309 over 307. i may get one.
i seriously thought about destroying one of my sticks to mount a fanta.
i seen a video one youtube on how to mount one to anystick.
i t requires a step drill bit but one of those cost like $50usd in my state.
I bought a big sheet of plexi at a local hardware store. It was 600x400mm and 4mm thick. The original plexi on the case (Venom fightstick) was 2-3mm thick. I used the leftover plexi to make a fightstick in my desk.
4mm was the minimum thickness they had unfortunately. A drill press made drilling holes easier.
I donāt think he works there anymore. Customer service lately has been lacking
My plan is to use a 35mm step-drill on my Madcatz TE and in the future see if tek-innovations could cut me a custom plexi if i ever wanāt art. But I donāt have the balls to take a fat drill to my precious TE anytime soon.
