Having an intermittent issue with my UFB where it will simply disconnect from the system (both PC and PS4). Unplugging the stick and plugging it back in fixes the issue. This only happens if the stick is in active use–I’ve left the stick plugged into my PC for hours at a time while watching Device Manager to see if it disappears, but it never disconnects if simply left idle.
Any idea what’s going on? I’m on the latest firmware, so I don’t think it’s a software issue. Is my board failing, or could there be another solution?
The official Pokken controller only works with the game Pokken, if Brooks board is mimicking the original controller it be limited to the same restrictions.
I asked this in the Hitbox thread so I’d figure I’d ask here too. I have a official PS4 Hitbox from the makers. I want to put a UFB in it. It looks like it might already have a 20pin but if that doesn’t work I can always screw each wire in. But my main question is the USB. In the Hitbox is looks like it’s soldered then hot glued to the board. Do I need to just cut the wires and solder it onto the UFB? If so where does it go on the UFB? I’ve installed a UFB in my Hori VLX but that was solderless with the EZMOD and all that. Lemme know please. Thanks.
I’ve modded a Hitbox and ended up soldering the USB cable to the 4 points at J6-1 (the USB points). If I recall correctly, it was all glued together and needed to be cut away, stripped, then soldered.
Noob question.My xbox360 did not recognise my arcade stick (it’s using brook ufb. Purchased from arcadestickindonesia). Do i need to press special button before connect it to xbox? Thanks for any help.