Should be no different than any other stick, cut and strip the wires and insert them into the corresponding screw terminals
You have to solder to use the guide panel just the the TE installs.
this psb works great for me, but i’m missing a way to select LS, RS and DS for the stick.
I updated my firmware and tested this in SFV training mode, and it works very well! This is going to make training significantly easier. Many thanks!
I believe if you leave the LS, RS and DS floating i.e. disconnected it should default to DP.
Most people refer DP.
TMI
Never mind I was wrong
Dude DP - D-pad or directional pad
ya don’t say
there’s no fisical connection for the selection on the board. i use DP for fighting games so no big issue, but some times i like to play other games with the stick too.
i don’t know if something like pressing tp+sel+l3 or something can be implemented/useful for such thing without interfering with normal function. may be if the mode can be activated on startup like the xinput mode it could work. even if the selection for the stick could be selected only at startup it would be useful (k1, k2, k3?)
get the UFB
Just wanted to drop in to say I also have this problem on my windows 7 machine, but not on my windows 10 machine.
For me, the Fight Board works perfectly on PS4 and my Windows 10 machine. I have had no issues at all.
@douglam
Please use the forcrd X-Input mode on PC to test again.
>> XInput mode : Press the OPTION(START) button then plug USB
um, so anything else i should try?
post some more pics of your soldering
more soldering pictures i guess http://imgur.com/a/xoQA0
since its a pcb, i guess im sorta screwed? It’s not the greatest soldering job, but it should still pass.
seems like gnd and d+ could be bridged on the back of the plate. do you have a tester?
try gently clean between the solder points with a cutter.
i have a tester, already mentioned that all 4 points of the usb are not bridged
Double check to make sure you did not mix up Data Minus and Data Plus with each other