no, nothing. also the board isnt hooked up to buttons yet (or the ends stripped yet), just want to make sure everything works before I put it in
What OS are you on? If you have only USB soldered and no buttons, you should be in business unless you have the wrong drivers. You need to have the 360 drivers from MS.
win 7, im not even getting an unknown device or anything. and i have drivers from MS
Are you plugging into USB2 or 3? Does your PC make the USB connection sound on plug in? Are you sure your USB is wired correctly? Do you have pics of the solder job?
no sound, tried both usb2 and 3. pics incomming
Um… Have you tried soldering an actual cable and not the header? You may have the pins wrong
no but i’ve tested that the connection is fine. really dont want to cut up a cable just to find out it doesnt work cause physics doesnt change. Pretty sure the usb is right, voltmeter is reading right when its plugged in.
Yes, I already have the latest 360 drivers installed. But to double check I uninstalled then installed them again.
Same problem.
@Twinniss
Please double confirm your soldering wires with USB cable and USB connector as below link…
tried different cables as well and did continuity tests on them to make sure they reach the board
Did you do a continuity test to make sure they aren’t bridged with each other? specially VCC and D-
I’m just curious about that installation. Is there a reason you’re hooking it up that way? What stick are you using and what is the cable hole situation?
just tried, they’re not bridged
I was just trying to use it for this weekend and then i was going to make it into a psx->ps4 converter via FGW converter. psx->ps3/ps4 converters were OOS at the time
For anyone who is interested, Brook has updated the Fight Board PCB with the updated SOCD and TouchPad / Select button remap for PS3/XInput http://www.brookaccessory.com/download/Fighting%20Board/
Thanks @GOGO.Zippy
@Noryia & Every Guys
Brook improved and added them in the latest version
(1)Adjust SOCD output setting
(2)Adjust button remap(On Xinput and PS3 mode,TP Key can be replaced with SELECT button
(3)Press START/OPTIONS then plugged in USB on PC, Run X-Input by forced mode
Many thanks to you for adding my suggestion to allow for TP to be SELECT on PS3! I really appreciate that you made it happen.
How does the touchpad emulation work? Going to guess that it allows you to hold left or right when pressing the TP button to get left/right TP presses, or press it with the stick at neutral for a middle press.
@blueNINE
Yes, hold D-pad then pressing the TP button to output left/right/up/down TP presses, or only press TP for a middle press
I put one in my Xbox 360 TE and want one to put in my old Tatsunoku VS Capcom stick to keep at a buddy’s house. Seems like everywhere is sold out? Also, anybody have any success replacing the PCB in the Wii stick?