Glad someone agrees! Been trying to justify making more than one for a while. :lol:
Make it or make it not, there is no justify.
/badyodaimpression
Is there anyone around here who does RJ45 cables for like a fee or something?
Has anyone ever successfully recolored sanwa buttons/balltops or something glossy of the like?
Sure, lots of people. Check the trading thread for modders and ask them. Iād happily do it, but Iām currently out of RJ45 ends, something I need to remedy likeā¦ today.
Man, Iāve got a dilemma here. Iāve got a PS3 SE full of sanwa buttons just sitting next to me. I could buy one of those round 2 TEās for 100 and dual mod it for myself with the spare ChImp Iāve got or I could modify the PS3 SE with the madcatz pad Iāve got on order. All the SE would need is a JLF.
I just canāt decide if the size and comfort of the TE is worth it over the portability of the SE. I donāt really mind playing on an SE either.
What do you guys think?
Iām kind of in a similar position, but i have a ps3 TE and a 360 SE. And I need one of em dual modded.
If size were the only deciding factor Iād go for the SE. I prefer compact sticks though so whatever your preference is.
I prefer big control panels on arcade machines.
Dual modding the SE is easier since itās on 360 (all you need is a Cthulhu/ChImp).
Wouldnāt it be a little tougher to stuff the pad PCB in the SE? To be fair, Iām really bad at organizing wires but all the same it looks a bit cramped in there.
Itās a 360 SE, he wont need a pad PCB. All he needs is a Cthulhu/ChImp.
Which begs the question: where IS a good place to put a 360 PCB in a PS3 SE? Iāve never been satisfied with the placement every time Iāve worked on one. Iāve tried putting 4716 boards on the taped-up pcb, under the start/select buttons at an angle, and just to the side of the stick. Any place better?
Unrelated, but I hate your new avatar! Bring back MAI!
Hmm, having removed my asii optical stick from the dreamcast stick that I bought, I see that all of the wires are yellowā¦
Thanks man! It works fine following that diagram, guess they ran out of coloured wires when they did this one
Hey what do people use to drill holes into a hrap case? Iām trying to put the start/select buttons on the back.
I use a 15/16 (24mm) hole saw I purchased at ACE Hardware. I do it by hand rather than with a drill.
Iām not sure if this is the right thread to ask (maybe the noob thread would be better?), but here goes:
Whatās the smallest functional stick anyoneās made? Iām guessing it would use an LS-33 and 24mm buttons. Iām thinking about an ultra-compact travel stick of sorts for my next-next project. Iād love to see some examples.
I think Gummoās keychain stick is the smallestā¦
Keychain?! Donāt tell me it was made from one of these O_O