You’d better contact 32Teeth… maybe its the resonator, maybe the chip needs to be re-flashed…
Hey PurpleArms. Can you add this image to the 2nd post? Its for comparing the spots I drameled to my snap in clears.
What connectors are needed to make my own wiring harnesses? Im on non working sparky #2 and if I cant get it sorted out Ill have to switch to an fgwidget.
thats the tricky part… custom cable headers / harnesses are not cheap to make unless in big bulk…
But here is what you can do… first, buy a bunch of female / female pre crimped wires from pololu:
Second, buy one of these housings… the pre-crimped wire will fit into those headers, and voila… instant custim header…
Will do… thanks for the pic!!!
Here is my cheat!
Spend $9 and get a 200mm 40pin ribbon cable peel what you need
Hey Mike,
that for the last package 
I`m now ready to start should I order your hoodies ?
Yes please! =D
Don’t forget the side pieces for the plexi stick (inner and outter wall), 2 corner pieces, and 4 aluminum feet!
1/4 stick of butter
quart of milk
and 4 aluminum feet for me too please
Can’t believe I missed this post.
Little known fact: I worked for college pro, it was the worst experience ever. Nearly killed myself with sub-par safety procedures and got paid not nearly enough to do it. worst.job.ever.
Also, don’t ever let them paint your house, if the workers are like my crew they don’t really care about the work other than getting it done. I drove by some houses we finished and you could blatantly see spots we missed lol
the ones i got where all civil engineers 
okay, ordered the stuff. And have fun with the milk and butter after one week travel.
yum, rancid
Evo Deal announcement!
Ok guys i’m headed to EVO. I will be there from July 27 to Aug 3 staying at the Gold Coast (next door to Rio).
I’m bringing arceye2 with me and arceye2 will be 20% off if you find me or Phreakazoid in Vegas!
Email me if interested!
hopefully you can then wear your hoodies…
Just setup my sparkypwn + arc-eye2’s to a xbox360 te without any type of dual mod board. AND I implemented the phreak mod on the bottom of the board with the resistor. after all that, i get 3 kicks that light up red, change to green, and then stay on green. I can use the buttons in game, but i get no response from the arc-eye’s. Right now I have the leads from sparkyPWN going into power lines of the buttons. I tried the ground side and that didn’t do anything either. Please help, I feel I’m close.
My pics are sorta bad so I got up a small video of the Arc eyes 2’s with the Sparky Jr. installed
[media=youtube]uDI1b2ol3dI[/media]
Just a few questions:
[LIST=1]
[]Skeletons. I really like the way Rollie Pearls look when lit being a nice even glow with no ‘skeleton’ showing. However, through multiple installs I’ve found that I tend to break snap-in button clips rather easily. Are there any non snap-in buttons that work well for being lit and also **don’t **show the button ‘skeleton’? The only other option I can think of is employing methods to block out the mid-section of the buttons and settle for just a “glow-ring” effect like kyored has above.
[]Are there any important tips to know when planning on using Arc-Eye2s with Sparky PWM v2 in conjunction with a dual-mod that utilizes a MC Cthulu board? (guess this is more of a sparky thread question…)
[/LIST]
sounds like something to do with sparky… can you post this over on the sparky thread?