Xbox One Padhack Trigger Issue

Tech Talk
1

Hey All,

Hoping someone can help me, my first attempt at any padhack and all going well until the triggers.

The diagram I was going off for the triggers is

.

However no matter which trigger I activate it always activates the LT.

I have also tried changing the points to the diagram

https://dl.dropboxusercontent.com/u/1570228/xbone%20backside.jpg

however again always the LT thats activated.

I have done a heap of searches and cant find anyone that has had the same experience.

Can anyone tell me if they have heard/seen this before?

Does this mean I did something wrong and have damaged the controller so trying to continue getting the triggers working is pointless?

Cheers

2

You need specific diodes, depending on which method you use to wire the triggers.

3

That is resistors not diodes you need for the trigger hack

4

I have tried with 100ohm resistors for each trigger and without. Both give the same result.

5

You need a 10k ohm resistor, 100 ohm is way to low of a resistance.

Check out this thread for more Info

6

Yeah checked out this page previously, however it only mentions the 10K resistors if you want to remove the two Analog cubes. I left them in, and in the post just above that section it states

“When connecting the triggers (RT & LT), you’ll need to use a 100ohm resistor”

7

I did some further testing and found that when the RT is activated it actually activates both LT and RT. I then got a magnet and placed it over the chips as indicated above in the second photo. The LT is actuated by the magnet however the RT is not. So im assuming I have damaged it somehow, is there any way around this?

8

Honestly this late in the game you are better off padhacking a 3rd party xb1 pad.
Only reason to use the 1st party is for wireless.

9

Hey all,
Having a similar issue to OP (it’s not just one trigger activating all the time in my case, neither works for me haha).

I have the 100ohm 0.5watt resistors on my wires coming off the triggers but the triggers are completely unresponsive.
Tested yesterday with a friends multimeter and found that when it completed the circuit from the board positive to the earthing wire, it sent a signal.

Can anyone with more experience give me some insight here?
I’m not sure where to go with it.

10

Those are something called hall effect sensors

11

I dunno about the op, but I fixed my issues up, thread here: Xbone Padhack Triggers