Guys i got 2 projects in the works atm, the 1st is simple using a PS360 PCB but the 2nd i thought i would save some coin and go 2nd hand parts.
I managed to grab a el cheapo wired USB X360 Controller. I disasembled the Pad down to its sexy naked PCB and now im stuck on the triggers. The LB and RB seem simple enough, the LT and Rt are not so easy…
I have taken off the Spring and trigger but the housing remains. It seems its solderied to the PCB from the Chip as per LB/RB.
Where do i soldier the Wires to?
If someone would link me a detailed guide or just post it here would be much appreciated. Goin the X360 controller route is saving me about $50+ as i al ready have spare wiring already installed with .187 clips.
Here are some pics.
http://i113.photobucket.com/albums/n231/crescenziomax/X360_03.jpg
http://i113.photobucket.com/albums/n231/crescenziomax/X360_02.jpg
http://i113.photobucket.com/albums/n231/crescenziomax/X360_05.jpg
http://i113.photobucket.com/albums/n231/crescenziomax/X360_04.jpg
This is a reference to go by but i can’t see the underside and how it was implemented.