Vewlix layout diagram

Tech Talk
1

Hey there. I’m building a new custom Jlf/ps-14kn/mayflash pcb arcade stick soon, and I need measurements so I can put the vewlix layout on my CP. This is the layout I’m looking for: http://slagcoin.com/joystick/layout/shift36_s.png. looks perfect, but there is absolutely no height measurements and without height measurements width measurements are rendered completely useless. Can anyone Show me a better diagram or help me out here I don’t know what to do. I also printed it out on 5 different settings and the 207 mm bottom turned into 230mm etc.

Thanks
Connor

2

the layout itself says 72 pixels per inch, you print in that resolution.

Also height measurements are dependent of the hardware you’re using and personal preference.

3

Don’t know about you, but I see height measurements in that.
For the spacing of Buttons and Joystick.
But I know you are not talking about that.

The height and length do not matter in a Layout.
It is up to you how big you want Control Panel to be.

4

No, I know that, It’s just the fact that I can’t figure out say the height difference between lp and mp, and I would like to have an accurate copy on my custom. Also The printer only prints in 600 dpi.

5

Oh, LP and MP?
There is height measurement in that image.

6

Oh yah lol. The thing I was wanting was the sides so I can lay it down on my panel and it would all be properly spaced much easier that way. I new I was missing something lol