Hey all.
This is a first for me. I tried searching for the info I’m looking for, but couldn’t quite come up with the right anwer.
I’m resurrecting an old project my brother and I started on a few years back, where he purchased some parts and then asked me to bail, since his wife bought him a new stick.
Now, I have a TVC stick I’d like to mod with the parts. I’ve already added the buttons, and they work fine. My problem is, I’ve got a non-JLF stick I’d like to replace the stock stick with. I’d have no problem doing this if I could get a pinout for the JLF connection, I suppose I could do a resistance ring-out, but I’m out of town right now, and this seemed like a good place to ask the question, so I’ll be ready to swap when I get back.
Again, sorry if reposted.
Thanks in advance.
Google is your friend.
Thanks! I think this will help. What I’m going to do is cut the JLF connection to the stick off and wire the connections with crimp conects, wasn’t sure if I mentioned that in my first post. I just think it’d be a waste not to wire up this stick…