Wassup y’all,
I had recently gotten my stick signed at a convention and I’m wondering what would be the best way to make the signatures last/remain as permanent as possible?
Spray a coat or two of non-acetone based clear coat over the autograph. I’ve used it with my signed items (photographs, baseballs, guitar, etc) with good results. Where it’s signed better not be at a point of contact (palm area especially) as friction and sweat will wear away even the clear coat over time
2 Likes
Unfortunately two of them are. One on each side of where my hands would go, unfortunately I didn’t think the placement of those thru b4hand.
Depending on what stick it is, maybe you can look into getting an additional plexi on top?
2 Likes
Yup. Putting something else over it would be my idea.
Yep. I used a thin clear plastic overlaminate sheet over the art of my Saturn sticks. That stuff will probably outlast the stick itself.
@ZiggyMC get yourself a thin sheet cut to fit the control panel area, or cut it yourself. I’ve ordered from Papilio in Texas (if you’re in the US). Their stuff is better than your average Staples/Office Depot crap.
1 Like