I shortened the wire and soldered the D+ and D- directly to the PS360+ and still no luck.
could have something to do with voltage, where is your vcc coming from and going to?
Well i’m sorta new to this so i followed Lemony Vengeance’s youtube guide, so i left the vcc connected to the xbox one pcb then just desoldered D+ and D- from the xbox one PCB and soldered them to the crossbone and then soldered the D+ and D- from sys 2 to the PS360+, that’s how it’s currently setup.
post pics
First one is the back of the xbox one PCB
Second is the front of the xbox one PCB
Third is the front of the crossbone
does your xb1 side work correctly? looks like your data lines are shorted on the back
also i was asking about your VCC line to ps360+. Is that going through your 20pin connector?
Yeah its actually working fine on the xbox one, and yeah, its running through the 20 pin connector. It actually works fine in every console except PC. I have to use the xbox one PCB for PC, wich sucks because the triggers dont work and i have to manually change the button wires if i want to use it that way
Just measured with my multimeter, im getting the full 5v on the PS360+ from the 20 pin header
did you try to plug it into the back of the computer? for me it solved the problem.
Other words different USB port.
So i wouldn’t need this then since the ps3/4 TE2 are common ground? i’m looking for one that just auto detects lol
No, this is only for xb1
There is no current solution for auto detection. There will always be a switch or button hold somewhere to switch between consoles
they need to get on it lol
In the meantime, is holding a button or flipping a switch that big of a deal?
Yup, no luck
You’re not using USB 3.0 ports are you? Could simply be the added power draw that your computer isn’t liking. Is this a desktop PC or laptop? Did you try a powered hub or just a regular one?
i plug in the back of my pc and it started to work
hi everyone ,first sorry for my inglish lol
i purchased mine on focus attack , i finish to put them on my arcade TE2 KI
everything good but ,on laptop no way to play with ps360+ ( i tryed with 2.0 & 3.0 0 usb) is work on xone mode,but no Lt/Rt
And if i sold the jumper “Led on” is always led? we cant turn off / on / haptic manual? by button (same like xone)
thanks again kinds regards
i have make same thing in my chunli Te-S Madcatz dual mod , using 20 pin without VCC & Ground on ps360+ with cable usb and it works on my laptop, so i think maybe it works with crossbone (not used 2 point red & black on crossbone too)
