SE into TE case

Is this relatively easy to do? I have a dead TE (not with me) but wasn’t sure if the insides of the SE will fit in the mounting positions inside the TE, just going to put my SE PCB inside that then buy a cheap second hand SE and put the spare Sanwa buttons I will have inside there.

I know the turbo panel will go in because it’s the same size but not sure about the rest of the stuff. :crybaby:

The rest of the stuff? The turbo panel is pretty much the entire PCB. :party:

iirc the PCBs for both sticks are completely identical, you should be able to swap them with no problem at all.

Some soldering will be involved though, as you will need to connect the USB cable to the new PCB.

Oh right I did not know that!

Is it possible to move the cable from the SE into the TE too? As in without soldering and keeping the cable the SE has already?

The only way to do that without any soldering would be to enlarge the hole for the USB cable until it’s big enough for the cable to go through.

it all fits but the se pcb dont fit proper u may have to shave or dremel out a small area where the turbo panel is on the se the cables clip to the back on the te they go to the side

Thanks guys, I will just solder the TE USB cable to the SE board as it is only 4 or so wires. :slight_smile: