there’s diagrams for the pinout of the ps360+ and the remora everywhere
Just connect the dots…
Sorry to bump a very old thread, but I recently dug some old stock out of storage and found a Remora 1.0 and set of ArcEye3s I never installed.
Plan on hooking this up to the Brook Universal board, far as I can tell all I need to do is strip the CN1 and CN2 ribon cables and feed them to the correct screw terminals on the Brook, along with wiring up VCC and Ground…
What I don’t know, since I can’t find an installation guide anywhere, is what the G, C, and V in the bottom left do, as well as E1 and E2 in the bottom right, or the unmarked connections along the top do.
G C V is answered somewhere in this thread, that is for Common Anode vs Common Anode functionality. For the UFB you can leave as is.
E1/2 is for extra LEDs. 1 forces the pulse animation if you hook up an RGB LED (have to tap from another button), and I forgot what 2 does. It’s all in the thread.
Unsure if this is a Remora issue or what it might be.
One of my LEDs is a dim red color, I assume to indicate an error.
Tried swapping cables, buttons LEDs, it’s always the same button, 3P on the Brook board. The button won’t register when pressed by the UFB or the Remora. Checking the button itself with a meter, it appears to fluxuate between +/- 2.5V when tested across the QDs on the button itself.
Shorting the 3P and GND on the UFB registers a press, so I am operating under the assumption something is going wrong with the Remora but am unsure how to proceed.
EDIT: Nevermind, I’m an idiot. One of the cables was crimped backwards and I swapped the wrong cable.
Anybody know how to turn on/off LED?