Quick Quesion about the 5 pin molex clip on MadcatzTE Sanwa stick

The Sanwa stick connects to the PCB with a little 5 pin Molex, Can I wire 4 Micro switchs
to a duplicate 5 pin molex for plug and play stick swap right to the PCB?

The stick I want to try out uses four switchs and fits and I prefer it and wanted to give it a go but I didn’t want to do anything permanent.


But the connector is not Molex.
It is a JST knockoff.

So you would just wire the “Ons” to the appropriate direction and a common ground right?



Thanks both of you, the rare occasion I’m doing something correctly is such a peculiar occurrence it requires independent verification.