Quick Help on JLF for SE Stick

Hello everyone, I’m new to the forums and modding sticks in general.

I noticed a problem with my Sanwa JLF-TP-8YT-SK or perhaps it was a result of bad wiring? My problem is that the stick will work fine and then it will switch over to the “right analog” as in the right analog on a controller. This happened once before but it ended up fixing itself when i replugged the connection although that’s not the case now.

I’ll provide some pictures if that will help you guys help me, thanks in advance! :slight_smile:

Make sure the switch on the turbo panel is set to DP, not RS.

I give you points for using the proper JLF-H cable and soldering it to the PCB, instead of using the same madcatz harness included. That is cool and right way to do it.

Aw it’s such a simple mistake T.T, I haven;t spent enough time with the stick to realise what those switches did, I usually just fiddle with them when they’re not plugged in. Thanks for your help, this thread can be closed ^^