I’ve decided to take on the project of creating a project box to connect my arcade stick to my Jaguar, but I can’t find a guide for where to solder on the Jaguar PCB anywhere on the interwebs. Has anyone done this or found one?
I tried looking at diagrams on slagcoin and he doesn’t have one either. Honestly you may be one of the first to try this so you may need a multimeter to figure out where ground and the signal lines are.
The Jag controller is pretty simple, it just looks complicated because the keypad.
Here’s a diagram:
Rather than makeking a padhack, I think it should be easier to redo the PCB on a protoboard without the keypad.
I’d prefer to padhack because I’d like to keep the keypad intact so I can place the controller next to my joystick and use the keypad.
Just like zombie ET cartridges, this topic is bumped.
I am willing to sacrifice a Standard Jag Pad fir my Jaguar Fight Stick.
I just.need 2 things. The solder points of a discrete joystick, and the proper mappings of Pro Controller buttons L R Z Y X, are if I remember right 4 6 7 8 9. This us thr cheapest way to make a Jag Pri Fight Stick, right?
May i have a solder point picture for my hired hand/ web friend to follow?