PCB help?

Tech Talk
1

i’m looking into dual modding my HRAP EX-SE, which PCB should i use? i need a pcb that works on the ps3 and ps2 emulation on the ps3.

2

ChImp.

And you need to replace the HORI PCB.
Because that PCB is non-Common Ground.
So use a Mad Catz Xbox 360 FightPad or Mad Catz #4716 Controller.

3

so i need to buy the pcb and an extra pad?

4

Yes.

5

will i need to drill any holes into the stick’s casing?

6

Not necessarily. If you are just doing a Mad Catz Pad + ChImp Mod you can use the existing USB cable hole, even the existing USB cable of the HRAP EX or Mad Catz Pad, or you can just buy a USB cable and plug that into the ChImps’ USB port. Just make sure you add strain relief. A good size knot on the USB cable on the inside of the case usually does the trick.

The hole drilling only necessarily if your adding a Neutrik USB or RJ45 Pass though. As your only doing a Dual-Mod and not a Multi-Console you don’t need the RJ45.