Mounting LS-32-01 instead of JLF

I’m going to buy the ls32-01 and mount it in an hrap ex box, problem is that the 01 comes with SS plate and I don’t know if I can mount it.
Should I also order a flat plate or I can mount it without problem?

P.S, there’s a ps3/pc cthulhu inside, the jlf has a pcb and 5pin cable

SS plate will fit in the HRAP EX no problem.

Thanks! was a bit worried earlier about having to do some irreversible modifications.

I Know they fit in TE/SE…and in some models of Hrap, take a look if your mounting bracket it´s the same of the TE.

Yes. HRAP EX has universal mounting Brackets. SS plate is what you’d be looking for.

Awesome, thanks, so I’m going for the 32-01

You wont be disapointed, Siemitsu > Sanwa imo…

I think that the xbox HRAP EX is not common ground. You need to get the LS-32 AND an SS plate. Don’t get the -01 version or you will have problems replacing the stick. I believe that the JLF used is the straight to Microswitch Version without a Harness. If JDM was here he would show you pictures.

If you open up the stick and look at the joystick:

If A) the joystick can be unplugged with a 5 wire harness than the above paragraph is incorrect. A LS-32-01 is fine

If B) the joystick has 8 individual wires with a pair going straight to Each microswitch, the the above paragraph is correct and you need to buy a LS-31 and an SS mounting plate.

Like I said earlier, it’s just the hrap ex case, the pcb is cthulhu, osbf30 buttons, JLF-TP-8YT-SK with the 5pin harness, so I really prefer to use the cable I already have connected to the pcb without any soldering, that’s why I want LS-32-01

Missed the P.S. part I read the first post yesterday before that was up, but didn’t post. Yeah 32-01 then.

Also just in case you have a Tek-innovations HRAP replacement panel, or plan to get one, you need the RE flat plate.

Missed the P.S. part I read the first post yesterday before that was up, but didn’t post. Yeah 32-01 then.

Also just in case you have a Tek-innovations HRAP replacement panel, or plan to get one, you need the RE flat plate.