Hey guys I’m finally wiring up my control panel. i have the paewang pcb board that I’ll be using with my xbox360/PC. The problem I’m encountering now is turning on my xbox360 (with paewang board plugged in) it comes on fine, but the console does not see the board until i unplug and re-plug again then the console connects to the board. I have to do this every time i power on my xbox 360 console. I did make sure it was synced accordingly by using the turbo button. Any idea guys??
photos of your wiring would help
Okay will do once i get home.
I would double-check the USB wire connection on the PCB as well as under the heat shrink sleeve. I have two Paewangs in my Kraylix as well, one I found wouldn’t work until I noticed the green wire near the heat shrink was broken. Once I cut and resoldered the wire, it worked fine after that.
Thanks bro I’ll check it out. I haven’t had much time lately to do any troubleshooting along with finishing the cabinet.