How do u take out the pcb and cord out of a hrap2

CAN someone tell me how take the turbo switch panel and ps2 cord out of the hrap case

i disconnected my stick buttons and the wires run to the turbo switch panel, which then has another set of wires coming out of the turbo switch panel that turn into the ps2 cord

the wires from the stick and buttons are glued onto the turbo panel, but the wires from the ps2 cord are connected to some white thing…is this white thing like the connector on the stick ??? and does it disconnect ??
( i didnt want to try to remove it and break it if it doesn’t disconnect)

the hole in the case the ps2 cord runs through is too small for the end of the ps2 cord to go through so how can i get the cord out ??? of the hrap

The connector for the cord to the PCB comes off, just tug on it a little. If you look at the HRAP from the bottom with the bottom plate off you will see 2 screws where the turbo switches and PCB are. Just unscrew those and the turbo button panel will come right off and the PCB is free to do whatever you want with it.

“The connector for the cord to the PCB comes off, just tug on it a little”

ok that’s what i thought, i just wanted to make sure and not rip it off if wasn’t supposed to

thanks tl613