on the hitbox the art is printed directly onto the plexiglass, i dont have an extra 20 bucks to spend and i dont mind losing the original “art” since its just plain black. How would i go about removing this “art”
If it’s etched in then there’s really no way to remove it.
any liquid thinners will likely damage the plexi, you’d be best off with the careful edge of a razorblade. this will also leave some damage but it might not show up as badly as liquid thinners or sandpaper. you can also sand the logo away and paint the whole plexi one solid color. the surface side will neatly show the color, i’ve done this before with TE artwork.
Try using a heat gun to soften the glue and pull it off. If not that then try rubbing eucalyptus oil in and pulling off the artwork.