i got two hori fight edge sticks with the touch screen. i am going to gut it out which i will be painting it and used the the touch screen. i need to know how to used the touch screen and home button to wire up the ps+360 board and get the lights up and running.
If you gut the Fighting Edge you lose the touch screen support
then how can i used the touch senor bar with the ps360. i know their gotta be a way to do it. i can see i can get around on the home button but i don’t wanna drill out two holes for start and back.
A roundabout way that’s probably counter productive and cost prohibited. Keep the Hori PCB inside, get the UD USB decoder, wire that up to the PS360+, put inside a project box and good to go. Or if there’s enough space, cram all those pcbs inside the stick.
The touch screen was intended to be used with the default PCB.
You can dual mod with that PCB, but Hori never had the PS360+ in mind.
well, it look like i have no choose by too take it out and add two 24mm buttons in the department where the usb cable go