^ Does this have anything to do with your ultra dremeled MC you tweeted over the weekend? lol
Thanks again for the mod at SB.
Maaaaaaaaaaaaaaaaaaaaaaaaayyyybeeeeeeeeeeeeeeeeee.
Although I’m using that one to put into a MS 360 controller…
Your welcome!
Did I ever tell you how much I love your avatar?
Yes, just now.
yo gummowned i got my T.E rewired by you and your team at sb and i must say thanks. but i have a sfac stick i would like to have rewired (i tried to do it myself) and also dual modded for ps2/ps3/xbox 360 use. and also my 8-way stick feels like i did something wrong when i installed it. how much would all of this cost with shipping to and from?
$130 to multi system mod the sfac stick and $10 for each cable that needs to be made. Shipping is around $15 if done via ground. What about the 8way stick feels wrong?
haha, gummo its you favorite stick…
real talk gummo can get this done simple… worth anything he says he did a awesome job on mine.
nothing more nostalgic then any fighting game on that this esp with a IL or p360 stick and some comp buttons to go with it…
also i suggest he puts the start and (select) on the front too and capping or getting a new plexi over the old ones, it’s mad godlike.
ok cool pretty much it just feels like i can go in certain directions. sometimes i cant jumpe up or it just feels like its not aligned up correctly. i would like to replace it with a better 8-way i dont know the difference between a happ and ill but i would like to have it close to a mas stick as possible.
which stick is your 8way in?
I think i have the ill comp in there…i dont even remember 
Hey Gummowned I was wondering if you could help me out? I need an alternate soldering point for the Right direction on the madcatz controller pcb board. The point is scraped off and I’ve tried soldering it again but I had no luck. Is there another soldering point for it? Thx heres a pic just in case.
http://imageshack.us/photo/my-images/526/img0832v.jpg/
Follow the small cable ribbon going from the dpad to the main board. You can use those contact spots.
Which one can u be a little more specific?
the one that looks like a ide cable. Follow the trace backwards to find a new contact pad.
the cable goes underneath the d-pad but they dont lead directly to any button? Do you know which wire i’d have to solder? 1st,2nd,3rd etc.
http://imageshack.us/photo/my-images/812/1320010756815.jpg/
http://imageshack.us/photo/my-images/824/1320010779105.jpg/
Use a multimeter and do a continuity test to find out. Or just take a ground lead and test it on each contact and see what direction gets registered.
Ok I found the point, now only 2 questions? Where do I solder the wire at. The side where the IDE cable is or underneath the D-pad? Do the wire’s share a connection or am I disconnecting the existing wire that is there to replace it with this one?