This may sound stupid, but since the Sanwa pcb is common ground and the Hori pcb isn’t, couldn’t you just use a terminal strip? Put the Sanwa ground in one end then solder the Hori grounds together and put that in the other end? That way you don’t have to break traces or swap out microswitches. Zero experience with this stuff, I’m going to ask a noob question now and then.
It wont work. The directions don’t have any common so basically each direction has two unique lines to complete the circuit.
Right, just a random thought. I’ll most likely pick up some cherry switches and swap them out, just bought one of these today. Thanks.
sorry for the huge bump but no reason to make a new thread when this one exists if i buy this stick and put a Sanwa JLW-TM-8 could i just add quick disconnects to the wires and put it on the points on the stick would that work i dont want to solder or mess up a pcb is anyway honestly. Picture of stick in question from lizardlicks.
Yes, that is what you do.
Just have to figure how to fit the Joystick in Case.
awesome thats great thanks a million off to buy the stick and well the stick loll