I install my Sanwa battop adaptor the wrong way and now it’s stuck inside of the battop. Any ideas on how to get it out?
How do you install it the wrong way?
Did you damage the threads while installing it by not seating it properly?
The adapter getting stuck in the bat top was a problem I had as well. I simply put it back on the shaft, tightened it, and it was more stuck on the shaft than that bat top, and unscrewed it. Then I had to take some mounting tap to wrap the adapter (so the threads don’t get damaged) and remove it from the shaft with a set of plyers. Either way, it’s a pain in the ass one way or the other - stuck in the bat top or on the shaft.
Still, I don’t see how it’s possible to put it on the wrong way.
It was just on too tight. I thought it on the wrong way was the reason it was stuck. It’s all fixed now.
I just don’t understand why the bat tops aren’t threaded for the shafts instead of using that stupid adapter.
I have the same dude. I have Sanwa bat top with scruw inside.
The scruw goes in the shaft or in the bat top inside?
de le ted
fixed.
Why is Sanwa is so Stupid to put the scruw out the bat top and not the scruw as the model Sanwa LB-30N clear that is put good as fatctory?
I installed a JLF extender and after testing decided it wasn’t for me. I did the same, wrapped a microfiber cloth on the threads and just torqued it with some pliers and it threaded just fine.