i accidently lifted/burned the back of the D-.
front is fine but still intact.
causing the pcb to malfunction on plugin, but green lights flash.
ps3+brawlpad w/ dpdt switch.
ps3 side works.
is there an alternative solder point?
pics of your pcb please, both sides.
which pcb did you burn on?
there are easy traces you can find on each that lead to either a zero ohm resistor which you can solder to or a trace you can make yourself by scraping the pcb with an exacto/craft knife
brawlpad.
will get pics in the morning.
The Trace goes to a 0 Ohm Resistor as mr.mortified said.
So solder to there.
If you messed up on the side of the Resistor going to Data- pad, then solder to the other side of Resistor.
got it go the 0ohm.
thanks.