0.110 quick disconnect - female to 2 males

Tech Talk
1

Is there a vendor who sells .110 quick disconnects that convert from 1 female to 2 males? I am looking to find these for a cleaner dual-mod solution i’m working on.

2

If you can fit two wires into a normal quick disconnect and crimp them well, you might be able to get a decent cold weld on both wires. The alternative is wire splicing to either tap into the existing wires or make a harness using male QDs, or alternatively using a terminal strip. What PCBs are being dual modded?

1 Like
3

Looking for something like this (https://www.amazon.com/Supco-T1122-Connector-Male-Female/dp/B0071NCK5M/ref=sr_1_1?ie=UTF8&qid=1524101682&sr=8-1&keywords=supco+connector)

but with 0.110 tab thickness.

I have some of these taps, but they are quite flimsy (https://www.amazon.com/Bestgle-Self-Stripping-Electrical-Connectors-Terminal/dp/B07114XHB8/ref=sr_1_3?s=industrial&ie=UTF8&qid=1524102013&sr=1-3&keywords=Bestgle+Self-Stripping+Electrical+T-Tap)

I dualmodded a smashbox with PS4+ audio board. It works, but, i’d like to make it look cleaner.

4

You could strip the wires then solder them and use shrink wrap to get a stronger splice. Unfortunately finding common electrical shit is often still like a needle in a haystack, it took me so long to find round rocker DPDT switches.

Mind posting a picture of the guts of the smashbox? I can’t find a picture online and it might help.

5

20180420_102118
20180420_1021183264×1840 1.58 MB

Here’s a terrible picture from a while ago (before i put the PS4+ w.audio in). I am on a work trip, not home yet. But, i will get you a better picture when i get home tomorrow.
Essentially,

I mounted the PS4+ to the left of the yellow buttons (the only space you have in this case to add a pcb). Wired the PCB and used the taps (amazon link i posted earlier) to tap into the sanwa connections. I drilled a hole on the left side and put the breakout board over there. The taps however are quite flimsy and not a lasting solution. The case looks very disorganized at the moment. I figured the female to 2 male connectors would let me use a dedicated harness and keep it clean. But, i can find a female to 2 male connector with a 0.110 tab thickness NOWHERE ON THE FKING INTERNET!!!

Edit:
However, i did find a piggyback connect that might work.