Is it possable to use this pcb with a sanwa harness ?
and is it posable to fit the screw on type in there ?
i don’t see why not… after you file/saw off the tabs in the button holes the screw-ins will fit… it’ll be annoying to fully tighten them (they’re just a tight fit… it’s not a big problem).
test everything first (just identify the ground before you desolder it from the stick, put it aside, then just twist the ends of each of the other 4 wires and make a note of which direction they all control (unplug the stick from the console when you’re changing something). to use the 5-pin wiring harness, you’ll need to take the wires from the stick, the 4 directions and the ground and join the wires in some way… either with a barrier strip or with some kind of solder/twist/electrical tape if you don’t wanna spend money.
Well what about the snap on ones ? woul i have to file the holes or they fit just fine also i just plan to have wire from the pcb to the buttons