still can’t find any 
Switches: http://www.ebay.com/sch/i.html?_sacat=0&_from=R40&_nkw=4pdt%20switch%20on-off-on&_sop=15
Batteries: http://www.ebay.com/sch/i.html?_nkw=18650+cell&_sacat=0&_odkw=18650+battery+cell&_sop=12&_osacat=0
Payment sent… Look forward to the board
yo gummo im going to order another leo but can u add an aditional flat ribbon cable?
If yes how much is it?
I can add an additional one, don’t worry about it. I gots shit loads of them.
Has it ever been discovered as to why L2 and R2 don’t work in MvC3/ UMvC3?
Just checking to see if you’re still selling these before I make an order. I’m not sure if you’d know this, but since the Leo is a common ground PCB that means it will work with the Toodles SOCD kit, right?
No it has not.
Yes I still have them for sale. It should work with the SOCD kit so long as that board will be ok running off 3.7v instead of 5v.
About to place an order for a couple of the boards, is there an extra charge to have the battery holder soldered on?
Also can screw terminals be used with the Double/Triple setup holes on the sides? If so what size/brand?
no charge for soldering on the battery holder.
screw terminals will not fit the holes on the sides.
Got my order, thanks! What is the name/size of these screw/standoff things? They’d be perfect for a number of things I want to do.
I have no idea.
So I decided to try out my leo board again and put it in a stick that uses a Wico P360. Essentially it works fine. however after about 30 minutes the guide button will start auto firing for no apparent reason. not really sure what’s going on but i basically wired the p360 up the same way the guide that was on aki shop showed to wire up a flash 1. It’s gets on your nerves but oh well. I’ve tested my wiring with a multimeter and everything seems to be okay.
edit: got it working okay for a session of marvel 2 earlier. then after a bit every face button was bringing up the xmb. odd.
I have a question, I just got a leo and was mounting it to the Sixaxis and saw that on the Sixaxis PCB I have there’s a tab between the two analog sticks on the PCB that’s jutting up, thus preventing the Leo v2 from mounting to the Sixaxis PCB. My idea now is to not bother mounting the Leo to the Sixaxis but just have them sit apart.
My question is:
I noticed that there seems to be a lead on the Leo going to the holes where the screws go, I assume these are used as grounds? And will it affect any thing by not having the Sixaxis PCB mounted directly to the Leo? I want to make sure as I’m total nubcakes at this modding thing. Any help would be appreciated.
They are connected to ground. Its ok not having the sixaxis mounted directly to the leo.
Thanks Gummo!
Hi Gummo, I’m interested in your Leo Board, do you have one available yet?
hi, i got leo v2 pcb and seems like i or previous owner fucked up pcb:(
right direction and select doesnt works in ps3 mode and triggers in xbox mode, do you have some leo v2 pcb diagrams or advices to look for?
Multi-meter
Sorry to necropost, but does anyone know if these are available from Gummods or anywhere else? I’d like to be able to use one of my sticks with the Vita TV when it comes to the states and want to use the db 15 port and a project box but I’d need a common ground solution. I think Leo is the only thing that fits the bill