Can the 4-pin usb header be used at the same time as the Usb B port?
I was wanting to see if i could install a usb led strip while the usb b port is used at the same time.
I wanna say the 4-pin usb header is labeled J6-1 on the board.
https://images-na.ssl-images-amazon.com/images/G/01/aplusautomation/vendorimagesUSBMBADAPT.Main.CB349175406.jpg
You may very well run into intermittent power issues at best, and a complete power cutout of the Brook board at worst. USB (typically, at least non-USB 3.1 G2[type-c]) only pumps out 5V at up to 1.5A(BC 1.2) It can be done Iām sure, but a step-up converter or chargeable internal battery with an aux board supplying stored current may be required.
AFAIK the header and port combo on the UFB (or PS4+A) are an āeither/orā scenarioānot both.
Be safe and drill another hole with another passthru. I did that on my Retropie stick with on-board battery, using an Adafruit Powerboost board to charge the batt that runs the pi. Iām pretty sure an LED strip (at least if you keep color at the red-side of the spectrum) could run effectively if I could so this with a Raspberry Pi
sorry for the barrage of edits. Iāve got a 102F fever (yet AGAIN!). FUCK 2018ā¦
Congratulations
Thā¦Thanks?
I replied to @Cyrox1, the post before yours. It has his picture in the upper right hand of my post.
I hate that upper-right-hand corner BS. Highlight their text. Hit the āquoteā button that appears on the text. Then finish your post
/mysterious
Itās quite harder to do on mobile.
When I use select all it selects the whole page lol
I do it all the timeā¦and Iām on an iPhone (the dumb beeotch of phones)
Ya gotta get that execution down, fella
See what I mean lol
I guess so lol
Is there any chance that this board will get direct input support? 360 mode is ok for most modern games but older ones either donāt recognize the trigger buttons (3K and 4K) as buttons so they canāt be mapped, or the stick isnāt detected at all.
I switched from a ps360+ to the UFB and I really liked the ps360+'s PC mode. Would it somehow be possible to use both boards at once so that the UFB would be used for consoles and the ps360+ would be used for PCs?
Dual mod it using the 20 pin header. I havenāt compared the two, since PS360s arenāt available any more, but totally doable. Youād need a DPDT switch though.
Xinput doesnāt work?
Thanks. Iāll look into that.
Could an existing ls/dp/rs switch be used instead of DPDT switch? If it canāt itās fine but itād make things a lot easier.
From what I understand, 360 mode is the xinput mode and that has the problems I described above.
Maybe try the ps3 mode. It would be 2P as you plug it into the computer based on what the Q and A I linked.
The only mode thatās detected as a controller is the 360 mode. I could probably get ps3 or ps4 mode working on my own computer by installing the drivers for those controllers but if I bring this stick to a tournament, I would want it to be recognized as a direct input device so I donāt have to worry about whether someone else has the right drivers installed.
