4291

The metal plate is almost flush with the top plastic so the plexi will be a bit less than 1/32" or so higher.

4292

Thanks Tensho, do you know if it irritates or becomes an an issue after extended play?

4293

It’s no issue for me, I have the same 1/32" plexi on my Fightstick Pro that’s not flush and it’s not sharp or anything

4294

Hey Art - I placed an order for 2 TE2 plexis but only got one. Sent you an email and a PM on srk but haven’t heard back. Please help if you can!

EDIT: He fixed up my order. ART YOU ARE THE MAN!!!

4295

Looking at maybe using one of the panel builder / TE Full plexi replacements for the top of a custom stick. Any reason not to?

Anyone know exactly what size it is? From the template, it looks like about 180mm x 280mm

4296

Art, I would interested in a full size hori scv replacement panel

4297

Art rarely comes around here. Why not order it from the site?

4298

what I’m looking for isn’t listed

4299

If it’s not listed, I don’t think Art can do it for you. IIRC, Art can’t do anything outside of his own product line (i.e. what’s up for purchase on his site already)

4300

You want a Hori SCV plexi but you want it to extend to the edge of the top? If so, I would email him.

4301

Any chance on a plexi for the Hori VLX?

4302

Any tips on getting the plexi to sit totally flat. On both my TE and my Kai they tend to bow a little between the screws.

4303

Try not to tighten the screws so tight. Had the same problem on my old Pro. tighten them snug( barely over hand tight) and the bow should ease.

4304

If you haven’t already done so, use a star tightening pattern to even preload distribution. Also consider that the plexi should be fastened at room temperature if you’re the type that likes to work outside.

4305

Hello,

I got a Plexi in 2011 for a Mad Catz TE Round 1, but it’s not flush with the bezel. The info I have on that order is:

If I got a 1/32" acrylic, would that be flush with the bezel? It’s not a HUGE deal, but I would really like to have a perfectly smooth top to the fightstick.

Thanks

4306

It should, your old plexi was 1/16" and the 1/32" is a lot thinner, so it should pretty much be flush with the bezel.(maybe 1mm or so higher?)

4307

I know that art allows the option to not cut out the turbo area when ordering a plexi. I’ve got a madcatz round 1 TE. Can I remove the turbo panel and still functionality? Will the stick be set to DP by default?

4308

the difference between the V3 and V.Hayabusa panels is just the four outer screws.

source: I ordered a V3 plexi and everything lines up except for those four screws. I’m a dummy.

4309

is the TE2 the exact same layout as the TE2+? I’m thinking about ordering some new art but wasn’t 100% sure they were the same dimensions in terms of button spacing/layout.

4310

I don’t understand the shipping cost :frowning:

V.S Center Plate Insert 2.50
Shipping 42.05

V.S Cover Reg-8 17.50
Shipping 17.10

I need V.S Center Plate Insert