More simple than I thought. Can’t be too careful, though.
Thanks.
Replacement Panel See sig
Newb question,i lost the bottom panel screw’s to a TE does any one have the measurements for them?
best way to mount a pcb in wooden box, without damaging box with screws?
Screws…
post edited.
Self-adhesive cable tie mounts + cable ties.
Self adhesive PCB feet with screws
I’ve seen a bunch of people with dual-mods that don’t have a switch or a new rj-45 connector, and they switch between the two pcb’s by holding down a button. Is there a specific tutorial for that mod?
They may be using an IMP board. If so then instructions are included with the pcb’s on how to do this, instructions also online. Can order direct from Toodles at http://www.godlikecontrols.com/
Easy to install if you know how to solder.
Re-asking here. I figured out that one connector on my PCB isn’t working anymore (specifically the one for MK), and I haven’t found any store online where I can re-order an SFIV SE Fightstick PCB. Can you even order them separately or do I need a completely new stick?
You can’t buy them separately. Brawlsticks are on sale at Gamestop for 30 bucks if you can find one. Not sure if the pcb would be a drop in replacement as they are slightly different, but you could just use the new stick. Drop ur sanwa parts into it if you have them.
I’m having a little trouble locating where I can buy some braided wire loom, basically exactly what is in this pic (hopefully mr. mortified doesn’t mind me posting his pic):
Can anyone point me in the right direction? I live near a Fry’s, if they would have it. I don’t mind ordering it from an online retailer though either.
Fry’s Electronics has it.
Great, thanks!
Yo, anyone know if the Plexiglass or anything is different with the Soul Calibur TE stick? Compared to Round 1 or Round 2 sticks? Im thinking of getting a full cover plexiglass with custom art on a Soul Calibur TE stick but don’t know if the dimensions are different. I remember hearing it has a type of jagged edge look which might cause problems?
Regular TE Acrylic will fit the SCV SOUL Edition.
But the holes for Buttons will not match up.
haha, nah i don’t mind man
that’ s a specific kind of wire loom
its split loop wiring.
basically it not a full circle and wraps around the wire. That’s how i could do the flat ribbon cables without folding/cutting/pushing the head of the connectors through the loom
For all the buttons or only the last 2? The last 2 buttons are majorly curved.
They won’t match up at all, the difference between the stick and buttons is different. However, even if they were the same, you would not be able to get six buttons to match up. The first two may match up, the rest up will certainly not.